Technical and economic substantiation of the air launch aerospace system parameters
Рубрика:
| 1Kalynychenko, DS, 2Man'ko, TA, 2Pavlenko, VM, 3Pavlenko, TYu. 1Yuzhnoye State Design Office, Dnipro, Ukraine 2Oles Honchar National University of Dnipro, Dnipro, Ukraine 3National Aerospace University «Kharkiv Aviation Institute», Kharkiv, Ukraine |
| Space Sci. & Technol. 2023, 29 ;(2):03-09 |
| https://doi.org/10.15407/knit2023.02.003 |
| Язык публикации: English |
Аннотация: The substantiation of the technical and economic parameters of the air launch aerospace system, which consists of a reusable unmanned aerial vehicle and integrated launch vehicle, is given. A combination of a turbofan engine and a ramjet engine is used as the unmanned aerial vehicle propulsion system. The considered vehicle is capable of delivering a payload into low-Earth orbits without the use of a spaceport. We have developed the methodology of the technical and economic substantiation of the parameters of the air launch aerospace system.
The results were obtained by searching for the minimum of the objective function, which established the relationship between the technical and economic parameters of the aerospace system. For the objective function solution, the design parameters of the integrated launch vehicle and unmanned aerial vehicle were determined, as well as the limitation of the total acceleration velocity of the aerospace system. The methods used allowed us to determine the velocity constraints provided by the operation of the turbofan engine, ramjet engine, and the three solid propellant motors of integrated launch vehicle stages, as well as maximum dynamic pressure and maximum permissible temperature on the unmanned aerial vehicle surface. We determined the scheme for estimating the cost of launching the spacecraft into Earth orbit by the air launch aerospace system.
The result of the substantiation is the determination of the technical and economic parameters of the integrated launch vehicle, unmanned aerial vehicle, and the aerospace system as a whole. The influence of the maximum temperature on the surface of the unmanned aerial vehicle and the specific impulse of the ramjet engine on the parameters of the aerospace system was also evaluated. The substantiation is the first step towards the creation of the Ukrainian aerospace air launch system.
|
| Ключевые слова: aerospace system, air launch, technical and economic parameters, unmanned aerial vehicle |
References:
1. Balakin V. L., Bebyakov A. A., Kochyan A. G. (2008). Optimization of the motion of a hypersonic aircraft-accelerator of a two-stage aerospace system. Bull. Samara State Aerospace Univ., № 1, 23-32 [In Russian].
2. Bebyakov A. A. (2013). Optimal control of the angle of attack of a hypersonic aircraft at the stage of acceleration-climb in the atmosphere. Bull. Samara State Aerospace Univ., № 1 (39), 26-38 [In Russian].
3. Kalynychenko D. S., Baranov E. Yu., Poluyan N. V. (2016). Formation of the efficiency criterion for the selection of design parameters of the aerospace system. Space Science and Technology, № 2 (99), 48-51 [In Ukrainian].
4. Badyagin A. A., Eger S. M., Mishin V. F., Sklyansky F. I., Fimin N. A. (1972). Aircraft design. M.: Mashinostroenie, 516 p. [In Russian].
5. Eger S. M., Mishin V. F., Liseytsev N. K., et al. (1983). Aircraft design: Textbook for universities. Ed. by S. M. Eger. 3rd ed., revised and supplemented. M.: Mashinostroenie, 616 p. [In Russian].
6. Blyznychenko V. V., Jur E. O., Krasnikova R. D., Kuchma L. D., Linnyk A. K., et al. (2007). Design and construction of launch vehicles: Textbook. Ed. of Acad. S. M. Konyukhov. D.: DNU Publ. House, 504 p. [In Ukrainian].
7. Khorolskyi M. S., Lavrynenko S. P., Potapov O. M., Kozys K. V. (2017). Prospects of creating the reliable thermal barrier coating systems from elastomeric materials for solid propellant rocket engines. Space Science and Technology, № 6 (109), 46-50 [In Russian].
8. Dietrich E. (2007). Koelle Handbook of cost engineering for space transportation systems: Statistical-analytical model for cost estimation and economical optimization of launch vehicles, revision 2, Report No TCS-TR-184. 283 p.
9. Greg J. (2006). Gstattenbauer Cost comparison of expendable, hybrid and reusable launch vehicles, AFIT/GSS/ENY/06-M06. 118 p.
10. Kalynychenko D. (2013). A technical approach to select design parameters of the air-launched space systems. 64th International Astronautical Congress, 7792-7799.
11. Kornev A., Stetsenko S., Yatsenko V., Smolyakov A., Kalinichenko D. (2021). Integrated Approach to Gas-dynamic Designing of Supersonic Air Intakes of Aircraft. Aviation., 25, No 1, 1-9.
12. Valerdi R. (2005). The constructive systems engineering cost model (COSYSMO): Dissertation doctor of philosophy. California, 152 p.